Can Superconductors Store Energy? The 95%-Efficient 'Battery' That Empties in Seconds


Have you ever wondered whether the same physics that keeps an MRI magnet switched on for years could also store electricity for your home?

Yes — a superconductor can store energy, and it does it more efficiently than almost any other technology. The catch is that it stores almost none of it.

The technology is called superconducting magnetic energy storage, or SMES. It stores electricity directly as a magnetic field, with no chemical reactions and no moving parts. Its round-trip efficiency is above 95%, the best of any storage system. And yet, after more than fifty years of research, you will not find one in a house, a car, or a phone. The reason is a single number: how much energy a kilogram of it can hold.

A glowing superconducting coil storing blue energy above a power grid


How a Superconductor Stores Energy

A SMES unit is three things: a coil, a refrigerator, and a power converter — nothing else.

Run a direct current through a coil of superconducting wire and a magnetic field builds up around it. The energy lives in that field, and the amount is set by a simple formula: E = ½ × L × I², where L is the coil's inductance and I is the current. Because the wire has zero resistance, the current keeps circulating on its own once the power supply is disconnected. In theory, the energy stays there forever.

Each of the three parts does one job:

  • The coil: Usually niobium-titanium wire, cooled by liquid helium to about 4.2 K (−269 °C). It carries thousands of amps with no loss at all.
  • The power conditioning system: Converts grid alternating current into the direct current the coil needs, and converts it back when the energy is released. This is also what makes the response nearly instant — power flows within milliseconds of the command.
  • The refrigerator: Keeps the coil below its critical temperature around the clock. This is the part most explanations skip, and it matters: the coil itself loses nothing, but the fridge runs 24 hours a day, 365 days a year.

Charging and discharging are just a matter of raising or lowering the current. There is no chemistry to wear out, so a SMES coil can cycle essentially without limit, and system lifetimes of more than 30 years are quoted. That combination — millisecond response, above-95% efficiency, unlimited cycling — is why engineers keep coming back to the idea.

The Numbers That Decide Everything

SMES wins on speed and efficiency, and loses badly on how much energy it can hold.

Put it next to the alternatives and the trade-off is impossible to miss:

Storage Energy per kg Round-trip efficiency Response time Best for
SMES 1–10 Wh/kg Above 95% Milliseconds Seconds of power
Lithium-ion battery 150–300 Wh/kg 85–95% Milliseconds Hours of storage
Pumped hydro About 1 Wh/kg 70–85% Seconds–minutes Days of storage

A kilogram of SMES coil holds 1 to 10 watt-hours. A kilogram of lithium-ion cell holds 150 to 300. That is a gap of roughly 25 to 30 times, and it is the whole story. SMES is a sprinter: it can deliver enormous power — its specific power reaches tens of thousands of kilowatts per kilogram — but only for seconds. A battery is a marathon runner by comparison.

Where It Actually Works: The Wisconsin Story

The one place SMES ever made money was fixing split-second grid problems.

In 1999, Wisconsin Public Service faced a familiar utility problem. Its Northern Loop, a 115 kV transmission system serving about 200 MW of peak load around Wausau, was prone to voltage sags. The permanent fix was a 250-mile, 345 kV line from Duluth, Minnesota — but that line would not enter service until 2002, and it would cost up to $15 million.

Instead, the utility bought six distributed SMES units from American Superconductor and GE, installed at five substations around the loop, for $4 million. When a voltage sag hit, each unit injected real and reactive power within milliseconds, stabilising the grid until the new line arrived. The units were the first commercial application of the technology on a utility grid, and they worked well enough that TVA ordered the tenth unit in September 2001, and Entergy installed units around Houston the same years.

The same logic still applies today. Semiconductor fabs, data centres, and other sites that lose millions from a single voltage blink use SMES for power quality — not to store energy for hours, but to bridge the fraction of a second before other systems take over. That is the niche where a device that empties in seconds is exactly what you want.

Your MRI Machine Is Already One

The best-known SMES on Earth is sitting in your local hospital.

An MRI magnet is a SMES. Once energised, current circulates in a closed superconducting loop with no external power, holding the field steady for years. The numbers check out with the same formula: a 1.5 T cryogen-free MRI magnet with an inductance of 52.49 H and an operating current of 300 A stores ½ × 52.49 × 300² — about 2.36 megajoules. A Siemens 1.5 T design stores 4.47 MJ.

That sounds like a lot of energy until you convert it: 2.36 MJ is about two-thirds of a kilowatt-hour, worth a few cents of electricity. The $80,000 repair bill after a quench is helium and lost scan time, not the energy in the field.

And a quench is what an uncontrolled SMES discharge looks like. When one spot of wire warms above its critical temperature, the whole coil turns resistive and all the stored energy becomes heat in seconds — which is why a quench is dangerous and expensive. For the full story, see our earlier posts: What Is Quenching in a Superconducting Magnet? and How Are Superconducting Magnets Made?

Why It Will Never Back Up Your House

The math kills it: a 1 MWh SMES would weigh 100 to 1,000 tonnes.

Run the worked example. One megawatt-hour is 1,000 kWh. At 1 to 10 Wh per kilogram, the coil alone would weigh 100,000 to 1,000,000 kg — before the cryostat, the fridge, and the power electronics. A lithium-ion pack holding the same energy, at roughly 150 to 200 Wh/kg at pack level, weighs about 5 to 7 tonnes.

The price gap is just as wide. Published estimates put SMES at roughly $1,000 to $10,000 per kWh of capacity, so a 1 MWh system costs $1 million to $10 million. A lithium-ion pack cost $115 per kWh in 2024 and $108 in 2025, according to BloombergNEF's annual survey — about $108,000 to $125,000 for the same megawatt-hour. The SMES figures are system-level estimates and the battery figures are pack prices, so the comparison is not exact, but even the friendliest end of the range leaves a gap of roughly 10 to 90 times.

Then there is the fridge. A battery sits quietly on a shelf; a SMES coil must be held near absolute zero forever, and the refrigerator's power draw never stops. High-temperature superconductors could change that arithmetic — a coil running at 20 to 77 K instead of 4.2 K would cut refrigeration power by one to two orders of magnitude — which is one reason the cuprate superconductors that work at warmer temperatures attract so much research attention.

The scale of the ambition shows in the history. A 1980s design study sketched a 20 MWh SMES — 40 MW for 30 minutes — and it was never built. Four decades later, installed systems still store a few megajoules to tens of megajoules each. The technology works; it simply does not scale into bulk storage.

The Seconds-vs-Hours Rule

Ask one question: is your problem measured in seconds or in hours?

  • Seconds — SMES wins: A voltage sag, a frequency dip, a factory line that cannot blink. Nothing else responds as fast or as efficiently, and the tiny energy capacity does not matter.
  • Minutes — either could work: Short bridging power while a generator starts. Batteries and flywheels usually win here on cost.
  • Hours — batteries win: Overnight storage, backup power, shifting solar energy to the evening. This is where SMES's 1–10 Wh/kg makes it a non-starter.

That rule is also the honest way to read the next SMES headline. If a startup claims a breakthrough battery replacement, check the energy density first. If it still quotes watt-hours per kilogram in single digits, the device is a power-quality tool, not a battery — however efficient it is.

Key Takeaway

Superconductors really do store energy — as a magnetic field, with above-95% efficiency and a response time measured in milliseconds. But a kilogram of SMES coil holds 25 to 30 times less energy than a kilogram of lithium-ion battery, and it costs 10 to 90 times as much per kilowatt-hour.

Superconductors are the fastest, most efficient way to store energy — and the worst way to store a lot of it. That is why the technology lives in substations and MRI rooms, not in your garage.

Sources:

 

Comments

Popular posts from this blog

Stargazing for Beginners: Your First Night Under the November Sky

How Profitable Is EV Battery Recycling? The Real Numbers for 2026

How Are Superconducting Magnets Made? The 650°C Bake, the −269°C Bath, and the 11.3-Tesla Test